Step Dimming

Integral LED Driver

 

This feature will set the brightness of all luminaires connected to the circuit to the same level. It is NOT possible to adjust the brightness of individual fittings connected to the same circuit using this function. If individually controlled luminaires are required please contact your Lumascape representatives for options. The luminaires are shipped from the factory set at 100% which is maximum brightness.


This feature is intended to set and forget the brightness level of the fittings. If luminaires are required to be adjusted regularly, contact your Lumascape representative for options.


If for any reason you become unsure or lost in the sequence, leave the luminaire ON for 30 seconds, and begin again.


Setting the light output:
Please read these instructions through completely before trying to change the light output level.
Although the times given are approximate, it is recommended that a watch or other timing device is used.


1. Switch the luminaire/s ON for at least thirty (30) seconds
2. Switch OFF, wait three (3) seconds
3. Switch ON, wait three (3) seconds
4. Switch OFF, wait three (3) seconds
5. Switch ON, wait three (3) seconds
6. Switch OFF, wait three (3) seconds
7. Switch ON, wait three (3) seconds
8. Switch OFF, wait three (3) seconds
9. Switch ON, wait three (3) seconds


The luminaire/s will now blink six times to alert you that it is about to enter programming mode. It is important that you allow this sequence to complete.


Once in programming mode the luminaire will automatically set to 100% of its maximum light output.


10. Switch OFF, wait three (3) seconds
11. Switch ON, wait three (3) seconds (now set to 90%)
12. Switch OFF, wait three (3) seconds
13. Switch ON, wait three (3) seconds (now set to 80%)


Continue this procedure until desired light output is achieved. (Note once the light output has reached 10% the next cycle will return it to 100%). When the desired output is achieved leave the luminaire ON. After a delay of approximately 10 seconds, the luminaire will flash several times, Once flashing is complete the light level will remain at this setting until this entire process is repeated from the beginning.